GoConqr has a new look! Let us know what you think.

Sign up free

Quiz

Software-Defined WAN I

Marcos Avila 11 questions 5.0 (1 rating)

Take the quiz

This quiz has question types that open in the usual player.

Questions in this quiz (11)

  1. 1SD-Wan configuracion setting needed:
    1. AMember interfaces
      Load balancing method
    2. BGroup member interfaces
      Load balancing algorithm
  2. 2[blank_start]Source IP[blank_end]: Traffic from the same IP address uses the same link.

    [blank_start]Source-destination IP[blank_end]: Traffic from the same pair of source and destination IP addresses uses the same link.

    [blank_start]Spillover[blank_end]: This method is similar to the spillover method used by ECMP. A link routes all the traffic until the volume reaches a threshold, after that, another link is used.

    [blank_start]Sessions[blank_end]: The interface weights determine the proportion of sessions that each link should handle. Sessions are distributed among the links, based on the interface weights.

    [blank_start]Volume[blank_end]: The interface weights determine the proportion of traffic volume that each link should handle. Sessions are balanced so that traffic volume is distributed based on the interface weights.
    1. ASource IP
    2. BSource-destination IP
    3. CSpillover
    4. DSessions
    5. EVolume
  3. 3Which method of load balancing is supported by SD-WAN but not supported by ECMP routing?
    1. AVolume
    2. BSessions
  4. 4Which of the following configuration tasks is correct when implementing SD—WAN?
    1. Aa. Configure a default route using the sd—wan virtual interface.
    2. Bb. Configure firewall policies for each individual member interfaces.
  5. 5SD-WAN Status check configuration available only via CLI: (select 3)
    1. Atcp-echo
    2. Budp-echo
    3. Ctwamp
    4. Dping
    5. Essl
    6. Fwarning jitter
    7. Gjitter
  6. 6Which one of the following link attributes is used in SD- WAN link quality measurements?
    1. Aa. Cost
    2. Bb. Latency
  7. 7Which of the following status check protocols is only available from the CLI? .
    1. Aa. TCP—Echo
    2. Bb. HTTP
  8. 8Which of the following is an SD—WAN rule matching parameter for traffic sources?
    1. Aa. User groups
    2. Bb. IPS signatures
  9. 9You can configure SD—WAN rules to choose the egress interface based on which one of the following parameters? .
    1. Aa. Cost
    2. Bb. Latency
  10. 10Which of the following should be used to monitor the session distribution across the SD—WAN member interfaces?
    1. Aa. SD—WAN Link Status monitor
    2. Bb. SD—WAN Usage monitor

Information

Description
NSE4 6.0 NSE4 6.0 Quiz on Software-Defined WAN I, created by Marcos Avila on 06/07/2018.
Language
Español
Views
183
Rating
5.0 out of 5 · 1 rating
Rate this quiz
Rate this quiz

Feedback

What is it about?

What do you think of the new look?

How do you like it?