Help shape GoConqr. What should we add next?

Quiz

CCNA – VLAN Questions

jonathan rozo 10 questions

Take the quiz

Questions in this quiz (10)

  1. 1QUESTION NO: 79
    What are three advantages of VLANs? (Choose three.)
    1. AVLANs establish broadcast domains in switched networks.
    2. BVLANs utilize packet filtering to enhance network security.
    3. CVLANs provide a method of conserving IP addresses in large networks.
    4. DVLANs provide a low-latency internetworking alternative to routed networks.
    5. EVLANs allow access to network services based on department, not physical location.
    6. FVLANs can greatly simplify adding, moving, or changing hosts on the network.
  2. 2QUESTION NO: 38
    What are three benefits of implementing VLANs? (Choose three)

    1. AA more efficient use of bandwidth can be achieved allowing many physical groups to use the same network infrastructure
    2. BBroadcast storms can be mitigated by decreasing the number of broadcast domains,thus increasing their size.
    3. CA higher level of network security can be reached by separating sensitive data traffic from other network traffic.
    4. DPort-based vlans increase switch-port use efficient,thanks to 802.1Q trunks
    5. EA more efficient use of bandwidth can be achieved allowing many logical networks to use the same network infrastructure.
    6. FBroadcast storms can be mitigated by increasing the number of broadcast domains,thus reducing their size.
    7. GVLANs make it easier for IT staff to configure new logical groups,because the vlans all belong to the same broadcast domain.
  3. 3QUESTION NO: 30
    VLAN 3 is not yet configured on your switch. What happens if you set the switchport access vlan 3 command interface configuration mode?
    1. AThe command is accepted and the respective VLAN is added to vlan.dat.
    2. BThe command is rejected.
    3. CThe command is accepted and you must configure the VLAN manually.
    4. DThe port turns amber.
  4. 4QUESTION NO: 145
    On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?

    Image for question 4
    1. Aa router with subinterfaces configured on the physical interface that is connected to the switch
    2. Ba router with an IP address on the physical interface connected to the switch
    3. Ca switch with an access link that is configured between the switches
    4. Da switch with a trunk link that is configured between the switches
  5. 5QUESTION NO: 80
    Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports Fa0/13. An 802.1Q trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the native VLAN is not specified. What will happen in this scenario?
    1. A802.1Q giants frames could saturate the link.
    2. BVLAN 10 on CAT1 and VLAN 1 on CAT2 will send untagged frames.
    3. CA native VLAN mismatch error message will appear.
    4. DVLAN 10 on CAT1 and VLAN 1 on CAT2 will send tagged frames.
  6. 6QUESTION NO: 40
    Which of the following are benefits of VLANs? (Choose three)

    1. AThey increase the size of collision domains.
    2. BThey allow logical grouping of users by function.
    3. CThey can enhance network security.
    4. DThey increase the size of broadcast domains while decreasing the number of collision domains.
    5. EThey increase the number of broadcast domains while decreasing the size of the broadcast domains.
    6. FThey simplify switch administration.
  7. 7QUESTION NO: 55
    A frame from VLAN1 of switch S1 is sent to switch S2 where the frame received on VLAN2. What causes this behavior?

    Image for question 7
    1. Atrunk mode mismatches
    2. Bvlans that do not correspond to a unique IP subnet
    3. Cnative vlan mismatches
    4. Dallowing only vlan 2 on the destination.
  8. 8QUESTION NO: 52
    Which statement about vlan operation on Cisco Catalyst switches is true?

    1. Awhen a packet is received from an 802.1Q trunk, the vlan id can be determined from the source MAC address table.
    2. Bunknown unicast frames are retransmitted only to the ports that belong to the same vlan.
    3. Cports between switches should be configured in access mode so that vlans can span across the ports.
    4. Dbroadcast and multicast frames are retransmitted to ports that are configured on different vlan.
  9. 9QUESTION NO: 60
    Which two benefits are provided by creating VLANs? (Choose two)
    1. Aadded security
    2. Bdedicated bandwidth
    3. Cprovides segmentation
    4. Dallows switches to route traffic between subinterfaces
    5. Econtains collisions
  10. 10
    QUESTION NO: 51
    Assuming the default switch configuration which vlan range can be added modified and removed on a Cisco switch?

    Image for question 10
    1. A2 through 1001
    2. B1 through 1001
    3. C1 through 1002
    4. D2 through 1005

Information

Description
Cisco Cisco Final Quiz on CCNA – VLAN Questions, created by jonathan rozo on 23/06/2015.
Language
Español
Views
1
Tags
cisco finalcisco
Rating
No ratings yet
Rate this quiz
Rate this quiz

Feedback

What is it about?

What should we add next?