HCIP 1

1. 1The role of Link-LSA in OSPFv3 does not include

   1. AAdvertise the IPv6 prefix list of this interface to other routers on the link
   2. BAdvertise the router's interface ID to other routers on the link
   3. CAdvertise the link-local address of this interface to other routers on the link
   4. DAdvertise the options set in the Network-LSA originating from this link to other routers on the link
2. 2An enterprise purchased private lines from two operators. In order to optimize the lines, the enterprise used BGP to learn routing entries from the two operators.However, the enterprise found that the traffic of the egress route increased greatly after this configuration. After the network engineering investigation, it was foundthat the traffic of the two operators was passed to each other through the enterprise egress router.
   Therefore, the enterprise intends to use the routing strategy so that the traffic of the packets of different carriers is no longer passed to each other. Is theconfiguration in the following figure correct?

   1. ATRUE
   2. BFALSE
3. 3By viewing DHCP configuration information and packet statistics, you can view the running status of the device and the count of DHCP packets received and sent,so as to locate problems during routine maintenance. Which of the following commands can be used to view DHCP messages directly? (Multiple choice)

   1. Adisplay dhcp statistics
   2. Bdisplay dhcp relay staitstics
   3. Cdisplay dhcp server statistics
   4. Ddisplay dhcp
4. 4According to this picture, what can we judge?

   

   1. AR1 needs to go through 2 routers to access 172.16.1.4
   2. BR1 needs to go through 4 routers to access 172.16.1.4
   3. CThere are 2 equivalent paths for R1 to access 172.16.1.4
   4. DThere are 4 equivalent paths for R1 to access 172.16.1.4
5. 5Configure ipv6 preference in IS-IS protocol view. The function of this command is to configure the priority of IPv6 routes generated by IS-IS protocol.

   1. ATRUE
   2. BFALSE
6. 6BGP4+ carries the next hop address of the IPv6 route through the Next_Hop attribute in the Update packet.

   1. AFALSE
   2. BTRUE
7. 7IGP converges faster than BGP, which may cause network traffic loss. By enabling the OSPF and BGP association feature of the device, the device can remain as a( ) router during the set association time, and the link metric value in the LSA advertised is the maximum value, thereby informing other OSPF devices not to use
   this router. to forward data to avoid traffic loss. (Note: If English letters are involved, all uppercase)

   1. ASTUB
   2. BSTUB.
8. 8By default, LDP adjacencies will trigger the establishment of LSP based on IP routing of 32-bit addresses.
   

   1. AFalse
   2. BTrue

Description

certificações HCIP DATACOM Quiz on HCIP 1 , created by Camila Silva on 14/12/2022.

Author

Camila Silva

Language

Português

Views

0

Tags

hcip datacomcertificações

Rating

No ratings yet

Rate this quiz

Rate this quiz

More on Network Devices and Routing