Sin título

Start

Mark/Trace out the measurements using a steel ruler,pencils and a tri-square

Cut the design from the material using a scroll machine

Shape the design using the materials

The shape of the artefact is obtained?

Is there a need to drill in a drill machine?

Remove the marks on the acrylic edges by filing

Is the marks removed?

Use the dry-wet sand paper to remove the marks on the edges

Drilled hole?

Drilling holes on the materials using the drill machine & using the correct drill bit

Soften the section on the acrylic using a strip heater

Bended the acrylic?

Fine marks have been removed?

using a buffing machine to polish the edge to make the edges shiny

Edges shiny?

Any section of acrylic that needed to be bent on the strip heater?

The making on this part of the artefact is finished.

End