Flashcards
Future of Microelectronics - Exam 1
Cards in this deck (28)
- 1How does a MOSFET current depend on temperature and why?Current = Charge*Velocity, charge does not change with temperature but velocity degrades. Current will decrease with temperature so chips run faster at cooler temperatures.
- 2How does a MOSFET leakage depend on temperature and why?Leakage current increases with temperature. When the transistor is off, there is a barrier for the source electrons to enter the channel. High temp causes more thermal emission over barrier --> increased leakage
- 3What is "volume inversion"?a phenominon that appears in very thin film MOSFETs due to inversion carriers that are not confineed near Si/SiO2 interface. Current and Mobility increase due to less interface scattering. The movement away from the interface lowers gate capacitance
- 4Physics of Volume Inversion?wave properties of electrons --> solving wwave equations (quantum mechanics) --> places charge in volume of the fin vs surface
- 5—1. Si
2. SiGe (Source/Drain)
3. Ti/TiN (Contact)
4. Tungsten (Contact)
5. SiON
6. Dielectric (SiO2) - 6—Form Fins
- 7—Use PR to cover needed patterns
- 8—Use Reactive Ion Etch to remove fin hard mast (fin cut into hard mask)
- 9—Mandrel remove leaving behind fin hard mask pattern
- 10—Planarized shallow trench oxide via chemical mechanical polish (CMP)
- 11—Removed SiN using wet etch
- 12—formation of dummy gate
- 13—Deposit Oxide to be used as an etching stopping layer
- 14—Deposit Nitride to be used for a sidewall spacer
- 15—Use PR to cover n region
- 16—Use RIE anisotropic etch to form sidewall spacers
- 17—Use RIE to recess pFET region fin
- 18—Epitaxy source/drain , SiGe for P region
- 19—Use RIE to recess sidewall spacer
- 20—Deposit Ni on epi for self-aligned silicide (NiSi) to lower resistance between transistor electrode and contacts
- 21—Replacement metal gate (RMG) process flow
- 22—Dummy gate removed via wet etch
- 23—Deposit high K material HfOx to form gate dielectric
- 24—Deposit TiN to be used in pFET metal gate stack
- 25—Cover P region by PR to remove the previously deposited metal from nFET regions
- 26—Etched contact holes to be used as local interconnect once metal (typically W) is deposited into the hole
- 27Few step modifications to fabricate Si nanowire transistors1. Fin patterning
2. Oxide filling and planarization
3. n-type fin recessing
4. SiGe and Si epitaxial layer
5. Oxide filling and planarization
6. p-type fin recessing
7. SiC and Si (hetero) epi layer
8. Oxide filling and planarization
9. Selective etch to form nanowire in channel
10. oxide/gate - 28How does a finFET work?gate wraps around fin for better gate control of channel
--> gate can act on 2-4 sides of the channel.
-->allow larger channel parameter (electrical width) to increase current flow.
--> better Ion/Ioff control
-->gate turns on transistos by inverting the channel
Information
- Description
- Flashcards on Future of Microelectronics - Exam 1, created by tiff walk on 16/02/2020.
- Created by
- tiff walk
- Views
- 0
- Rating