Help shape GoConqr. What should we add next?

Flashcards

Chapter 11 Diodes and Power Supply Circuits

pete.c.diaz English 48 cards

Cards in this deck (48)

  1. 11. How many diode are use by a full-wave center topped (CT ) transformer rectifier circuit?2
  2. 2A dc power supply circuit may be built into a sub-system or constructed as a:Regulator
  3. 33. Utilizing the same transformer the average voltage output from a bridge rectifier is:# 395 higher than a full-wave rectifier
  4. 44. A manufacturer’s limits on a diodes’ reverse bias voltage is called theReverse break down voltage.
  5. 55. What is the peak secondary voltage of a 14:1 sop-down transformer when 120 v ac ms is applied to the primary? *VP=12.12V
  6. 66. In a diode schematic symbol, the arrow always point toward theAnode
  7. 77. If the dc average is 25 v and the RMS of the ripple voltage is 3.54 V what is the percent of ripple?*706.2
  8. 8*8. Whit a diode’s manufacture the n material is mechanically connected to the:anode load
  9. 99. A diode constructed of germanium will have a barrier potential of :0.3 V
  10. 10*10. When the capacitor valve in a competitive filter circuit is increased the changer makes the time constant stoner which whit:decreases ac ripple
  11. 1111.11
  12. 12*12. When checking diodes what does a low resistance reading in either direction tell me?diode is shorted
  13. 1313. With 169 Vp ac input to a 1:6 power supply transformer, what will be the input voltage (RMS) to the rectifier?*720 V
  14. 14*14. What is the p-type material within a diode called?anode
  15. 15*15. Leakage current in a diode is very small and caused by:?
  16. 1616. If a forward biased voltage of 0.7 V is read across-a diode it is US Van constructed of.Silicon
  17. 1717. Because all of the ac input is not converted to its dc load a power supply is not 100%.efficient
  18. 18*18. What makes the discharger time constant of a capacitive filter longer than the charger time??
  19. 19*19. A bridge rectifier, unlike the full-wave rectifier provides:The total peak secondary across the load
  20. 2020. When a 6 V dc source, a forward biased silicon diode, and a 1 K ohm resister can be: *5.3 V
  21. 2121. In a full-wave CT rectifier, current must always flow in the same direction through?The input transformer
  22. 22*22. What is the average voltage of the pulsing dc output when the input to a half-wave rectifier is 48 Vpp ac? 48Vpp/2 = 24 Vp/2 = 12.0.637= ?7.644V
  23. 2323. In a diode , what is the name of the point where the two oppositely dipody materials come in contact?junction
  24. 24*24. What is the peak output voltage of a filter circuit whose affective voltage should be 15 V Quf the ac ripple 100 mV pp?15.050 V
  25. 2525. The direction of installed diodes determines thepolarity of the output
  26. 2626. What is the current through the LED?8.4 mA
  27. 2727. What is the current through the germanium diode?11.7 mA
  28. 2828. W26. What is the current through the LED?19.3 V
  29. 2929. What is the current through the LED?38V
  30. 30A full-wave rectifier circuit using four diodes that will convert an alternating voltage input into a direct voltage output.Bridge rectifier
  31. 31What is a circuit that produces different output voltage codes, depending on the position of a rotary switch.encoded circuit
  32. 32What is a semiconductor diode whose ON?OFF characteristics occur at a junction between the n-type and p-type semiconductor materials.junction diode
  33. 33voltage that inclines or causes the diode to operate in a certain manner.bias voltage
  34. 34Formula: The Junction Diode Current Characteristic CurveVs-V diode/Rs = If
    If= ?
  35. 35The point on the reverse voltage scale at which the diode breaks down and there is a sudden increase in the reverse current.breakdown voltage or peak inverse voltage
    (PIV)
  36. 36Diodes constructed to operated at voltage that are equal to or greater than the reverse breakdown voltage rating.zener diode
  37. 37The undesirable flow of current through a device in the revers direction.reverse leakage current (Ir)
  38. 38The voltage drop across the zener when it is being operated in the reverse zener breakdown region.zener voltage(Vz)
  39. 39A semiconductor device that produces light when an electrical current or voltage is applied to its terminals.light-emitting diode
    (LED)
  40. 40What is the typical forward drop across a silicon diode?0.7 V
  41. 41What value of barrier voltage has to be overcome in order to forward bias a silicon diode?0.7 V
  42. 42How many P-N junctions are within a junction diodeone
  43. 43In most applications, a zener diod isrevers biased
  44. 44The zener diode is designed specifically to operate atvoltages exceding breakdown.
  45. 45LED Formula:Vs-V LED/Rs = Is
  46. 46Formula: Full-Wave Bridge RectifierV avg = 0.636 x Vs peak
  47. 47output pulsating dc ripple frequency = 2 x input ac frequencyV out = V s peak - 1.4 V
  48. 48The barrier voltage for a silicon junction diode is:0.7 V

Information

Description
Flashcards on Chapter 11 Diodes and Power Supply Circuits, created by pete.c.diaz on 14/05/2014.
Created by
pete.c.diaz
Views
36
Rating

Feedback

What is it about?

What should we add next?