Mind map
Pipes and Hoses 586 - 592
Map content
Pipes and Hoses 586 - 592
Extruded tube materials - non-corrosive steels, aluminium and titanium alloys
Dimensions determined by external diameter and wall thickness
High pressure Line - 1500psi
Medium pressure Line - Under 1500psi
- Preferably made from aluminium
Low pressure Line - Suction and return lines
Vibration kept to a minimum by clamping at regular intervals
Smallest bend radius determined by material, wall thickness and outer diameter
Support Clamps
- Two types most commonly encountered
- Plain clamp
- Rubber cushioned
- Secure lines subject to vibration
- Used to secure fluid lines to aircraft assemblies or structure
- Two types most commonly encountered
Bonded Clamps
- Secure metal fuel, oil or hydraulic lines
- Electrical lead connected to the aircraft structure to the ground line
Tube Fittings
- Flareless Fitting
- Ball-bush principle for seal
- MS Fitting
- Sleeve or O-ring is shaped by pre-stressing in a way that its inner cutting edge is pushed over the pipe to seal it
- Harrison Fitting
- Ball-bush as a seal
- Not moulded
- Tube is moulded
- Swaged in the sleeve from the inside so it is tightly sealed
- Tube not allowed to touch the end of the fitting
- Advantage - Ease of handling, simple tool required for installation
- Ball-bush as a seal
- Flareless Fitting
Information
- Description
- Aeronautical Engineering (M7 Mindmaps) Mind Map on Pipes and Hoses 586 - 592, created by Kenzie Evans on 06/09/2017.
- Created by
- Kenzie Evans
- Views
- 0
- Rating
More on Aircraft Hydraulic Systems