Flashcards
Year 7 workshop test
Flashcards do conjunto (23)
- 1Q: Pine is a type of what? Hardwood, Softwood or Manmade BoardA: Softwood
- 2Q: Oak is a type of what? Hardwood, Softwood or Manmade BoardA: Hardwood
- 3Q: Plywood is a type of what? Hardwood, Softwood or Manmade BoardA: Manmade board
- 4Q: What type of Glue do we use on wood?A: PVA
- 5Q: What is the difference between a Rule, and a Ruler?A: A Rule starts at zero, so it can be used to measure depth.
- 6Q: What type of mechanical fixing do we used to hold wood together while glue sets?A: Nails or Panel Pins
- 7Q: What is the name of the hammer with the pointy wedge end?A: Cross Pein Hammer or Warrington Hammer
- 8Q: What is the name of the hammer with the ball end?A: Ball Pein Hammer
- 9Q: What is the name of the tool used to remove nails?A: Pincers
- 10Q: Acrylic is a type of what plastic? Thermoplastic or Thermoset.A: Thermoplastic, because it can be heated up and reshaped.
- 11Q: A Forstener bit us used for what?A: Drilling holes
- 12Q: Acrylic can be cut with what types of saw?A: Coping, Hacksaw and Junior Hacksaw
- 13Q: Wood can be cut with what types of saw?A: Tenon saw, Coping saw and a Fret saw
- 14Q: What protective equipment should be worn when using the Disk Sander?A: Apron and Goggles
- 15Q: What protective equipment should be worn when using the Pillar Drill?A: Apron and Goggles
- 16Q: What protective equipment should be worn when using the Polishing Mop?A: Apron and Goggles
- 17Q: What is the white line for in the work shop?A: To show that only one person should be at each machine, at any one time.
- 18Q: What type of hole should you drill for a screw, if you want a tight fixing?A: Pilot hole.
- 19Q: What type of hole should you drill for a screw, if you want a loose fixing?A: Clearance hole.
- 20Q: What vice is best suited for holding wood?A: Bench or Woodwork vice
- 21Q: What vice is best suited for holding Acrylic?A: Bench or Wood vice: The wooden jaws do not mark the plastic.
- 22Q: After Draw filing Acrylic, what is the next process to finish off the surface?A: Removing file marks with Wet and Dry paper.
- 23Q: What is the final step of finishing off Acrylic, after you have finished Wet and Drying the surface?A: Polishing; using the Polishing Mop
Informações
- Descrição
- Test to be taken in the last lesson to test subject knowledge.
- Criado por
- mstokesteststudent
- Visualizações
- 21
- Tags
- Avaliação