Ajude a dar forma ao GoConqr. O que a gente deve adicionar?

Mapa mental

EtherChannel

Alejandro Castillo Ingeniería Espanhol

Conteúdo do mapa

EtherChannel

  1. Layer 2 EtherChannel

  2. Layer 3 EtherChannel

    • The following checklist shows the steps, assuming a static definition for the EtherChannel: 1-Configure the physical interfaces as follows, in interface configuration mode: A. Add the channel-group number mode on command to add it to the channel. Use the same number for all physical interfaces on the same switch, but the number used (the channel-group number) can differ on the two neighboring switches. B. Add the no switchport command to make each physical port a routed port. 2-Configure the PortChannel interface: A. Use the interface port-channel number command to move to portchannel configuration mode for the same channel number configured on the physical interfaces. B. Add the no switchport command to make sure the port-channel interface acts as a routed port. (IOS may have already added this command.) C. Use the ip address address mask command to configure the address and mask.
    • Layer 3 EtherChannels do require a few consistency checks between the ports before they can be added to the EtherChannel. The following is the list of requirements for Layer 3 EtherChannels: -no switchport: The PortChannel interface must be configured with the no switchport command, and so must the physical interfaces. If a physical interface is not also configured with the no switchport command, it will not become operational in the EtherChannel. -Speed: The physical ports in the channel must use the same speed. -Duplex: The physical ports in the channel must use the same duplex.

Informações

Descrição
Ingeniería Mapa Mental sobre EtherChannel, criado por Alejandro Castillo em 22-10-2018.
Visualizações
1
Avaliação

Mais sobre EtherChannel and Link Aggregation

Fale Conosco

Sobre o que é sua mensagem?

O que a gente deve adicionar?