Ajude a dar forma ao GoConqr. O que a gente deve adicionar?

Mapa mental

1.3.2 Networks (cont again)

Alexandra Russell Computing A level Inglês

Mind map about networks wired, switched and packet switching: copper, fiber and routers

Mind map: Networks wired switched packet switching

Conteúdo do mapa

1.3.2 Networks (cont again)

  1. Wired

    • Copper (Gigabit or more)
      • Reliable
      • Can suffer from “cross talk” or interference
      • Signals fade around 100m and require amplification
    • Fiber (speed of light)
      • No electromagnetic interference
      • Much less loss of quality over distance
      • Total bugger to terminate/splice/join cables
      • ADVANTAGES OVER COPPER
        • A single optical fibre can carry over 3,000,000 full-duplex voice calls or 90,000 TV channels
        • Immunity to electromagnetic interference even electromagnetic pulses generated by nuclear devices.
        • Light transmission through optical fibers unaffected by other electromagnetic radiation nearby. The optical fiber is electrically non-conductive, so it doesn't act as an antenna to pick up electromagnetic signals. Information traveling inside the optical fiber is immune to electromagnetic interference,
        • Low attenuation loss over long distances
        • Don't conduct electricity, preventing problems with ground loops and conduction of lightning
        • Can be strung on poles alongside high voltage power cables.
        • Conventional cable systems use large amounts of copper. In some places, this copper is a target for theft due to its value on the scrap market
        • Copper can be tapped with very little chance of detection.
  2. Switched

    • Number of switches set to create path along which data can be sent - Old telephone system
      • Switches set in exchanges between caller and receiver and path maintained while call made
        • Each switch is a possible cause of interference and unsuitable for transmitting data
  3. Packet switching

    • Path created between two sites
      • No other users can use the connection whilst it is in use
        • All data travels down this one path
          • If path fails, connection fails
    • Packets usually contain:
      • Data being sent
      • Address of source and destination of data
      • Checksum for purposes of checking that data hasn't been corrupted
      • Data which enables data to be re-assembled into its original form
      • The exact structure is protocol defined
    • Routers at various points along the way read the packet and send it either to, or closer to, its destination
      • Data packets may travel completely different routes to their destinations
        • Upon arrival, data can be reassembled from the packets – they DON’T need to arrive in order
    • Advantages
      • Not affected by failed link, as there are a number of different routes packets can take
      • If packet is lost, transfer doesn’t fail – packets can be re-sent causing only very short delays
      • Good level of security as its difficult to intercept a transmission

Informações

Descrição
A level Computing (1.3.2 Networks) Mapa Mental sobre 1.3.2 Networks (cont again), criado por Alexandra Russell em 30-11-2016.
Visualizações
3
Avaliação

Fale Conosco

Sobre o que é sua mensagem?

O que a gente deve adicionar?