Ajude a dar forma ao GoConqr. O que a gente deve adicionar?

Slides

Nuclear Decay

Haneen Al-Baghdadi Physics A-Level Inglês 24 slides

Slides do conjunto (24)

  1. Background radiation

    • Humans can survive small doses of nuclear radiation relatively unscratched.
    • Background radiation is the low level of radiation emitted from both natural and man-made sources,
    • We can measure background radiation using a Geiger-Muller tube, the number of counts per second usually ranges from 0.5 to 30,
    • Radiation levels are often reported in counts per second, and this unit is called becquerel (Bq),
    • The actual exposure to nuclear radiation that any individual will receive from their environment will depend on where they are and how long, as different environmental factors contribute to the local level of background radiation.
    • The background count will skew the results of investigations into nuclear radiation.
    • https://www.youtube.com/watch?v=sxbPwl_KRuA (Incorporar)
  2. Types of nuclear radiation

    • Many nuclei are slightly unstable and there is a small probability that, in any time interval, they may decay. This means that a nucleon may change from 1 type to another, or the composition or energy state of the nucleus as a whole may change.
    • The three main types of nuclear radiations are:
    • Alpha
    • Beta
    • Gamma
    • Each 1 comes about through a different process within the nucleus, each 1 is composed of different particles, & each 1 has different properties.
    • https://www.youtube.com/watch?v=Zw0pHT47AAU (Incorporar)
  3. What happens in nuclear decay?

    • Unit 5: Nuclear and Thermal Physics
    • When a nuclear decay happens, the radiation particles emitted will leave the nucleas with a certain amount of K.E.
    • As the particles travels, it will ionise particles in its path, losing a small amount of the kinetic energy at each ionisation.
    • When all the kinetic energy is transferred, the radiation particles stops and is absorbed by the substance it is in at that moment.
  4. Alpha Particle

    • https://www.youtube.com/watch?v=3koOwozY4oc (Incorporar)
    • Alpha particles are composed of 2 protons and 2 neutrons, the same as a helium nucleus.
    • It is a relatively large particle with a significant positive charge (+2e), so it is highly ionising.
    • As it ionises so much, it quickly loses its K.E and is easily absorbed. A few cm travel in air is enough to absorb alpha particles/
    • They are easily blocked by paper and Alpha particles travel at high speeds.
    • It's possible for Alpha particles to be deflected by very strong electric and magnetic fields.
  5. Beta radiation

    • Atoms and Radiation
    • Nuclear Physics: Quiz
    • A beta particle is an electron emitted at high speed from the nucleus when a neutron decays into a proton.
    • With its single negative charge and much smaller size, the beta particle is much less ionising than an alpha particle, and thus can penetrate much further.
    • It can travel several meters in air.
    • A thin sheet of aluminium can absorb the beta particles.
    • If you use Fleming's left hand rule, you can show that beta rays must be negatively charged particles. This can be seen when a person place a powerful magnet in GM-tube and counter as the count rate falls but rises again when the GM tube is moved.
  6. Gamma rays

    • Gamma rays are high energy, high frequency, electromagnetic radiation.
    • These photons have no charge and no mass and so will rarely interact with particles in their path, which means they are the least ionising nuclear radiation.
    • They are never completely absorbed, although their energy can be significantly reduced by several cm of lead, or several meters of concrete.
    • If the energy is reduced to a safe level, gamma rays are often said to have been absorbed.
    • Gamma rays
  7. How is radiation absorbed?

    • Alpha, Beta & Gamma particles are all very energetic particles. Their energies are often measured in eV rather than Joules.
    • Radiation ionise molecules by 'knocking' electrons off them. As it does so, energy is transferred from the radiation to the material.
    • Why do 3 types of radiation have different penetration power?
    • Alpha particles as we know is heavy, relatively slow-moving particles with a charge of +2e.. It interacts strongly with matter. After passing through a few cm of air, it loses its energy
    • The gamma ray photon interacts weakly with matter because it is uncharged and therefore it's difficult to stop. A gamma ray photon often loses all of its energy in 1 event.
    • However the chance of such an event is small and on average a gamma ray photon travels a long way before it's absorbed.
    • Beta particles are much lighter than alpha particles and so travels much faster. Since it spends just a short time in the vicinity of each air molecule and has a charge of only -1e.. It causes less intense ionisation than the alpha particles.
  8. Probability & decay

    • Radioactive decay is a spontaneous and random process, any radioactive nucleus may decay at any moment. For each second that it exists, there is a certain probability that the nucleus will decay.
    • This probability is called the decay constant.
    • It isn't possible to predict when any given nucleus will decay. The likelihood that a particular nucleus will day isn't affected by factors outside the nucleus, e.g temperature & pressure, Each nuclear acts entirely independently.
    • If we have a large sample of nuclei, the probability of decay will determine the fraction of these nuclei that will decay each second. Naturally, if the sample is larger, then the number that decay in a second will be greater.
    • So the number decaying per second is called Activity, A and is proportional to the number of Nuclei in the sample, N.
    • Probability & decay
    • Legenda: There should be a minus sign because the number of nuclei in the sample will decrease but we often ignore it mathematically.
  9. Another formula for rate of decay

    • Another formula for rate of decay
    • The formula for the rate of decay of nuclei in a sample is a different equation..
    • This type of equation is called the exponential equation as seen in the right.
    • The equation on the right can be used to solved the number of nuclei remaining in a sample N, after a fixed time t. The other N is the initial number of nuclei within a sample and the lambda is the decay constant
    • Legenda: A stands for activity
  10. Half-life

    • The activity of a radioactive sample decreases over time as the radioactive nuclei decay.
    • While the activity of a sample depends on the number of nuclei present, the rate at which activity decreases depends only on the particular isotopes.
    • A measure of this rate of decrease of activity is the half-life.
    • Half life is the time taken for half of the atoms of that nuclei within a sample to decay.
    • Half-life
    • Legenda: This is the mathematical equation of the half-life
  11. Half-life graphs

    • An experiment to determine the half-life of a substance will usually measure its activity over time.
    • As activity is proportional to the number of nuclei present, when the activity is plotted against time, the shape of the curve is exponential decay.
    • We can use the graph of activity against time to determine the half-life of the substance by finding the time taken for the activity to halve.
    • To find the half-life from such a graph, find a useful start point on the curve.
    • Half-life graphs
  12. Energy-mass equivalence

    • Energy-mass equivalence
    • We might expect that if we know the constituent parts of any nucleus, we can calculate its mass by finding the total mass of its nucleons.
    • However, in truth we find the actual, measured mass of a nucleus is always less than the total mass of its constituent nucleons.
    • This difference is called the mass deficit, or sometimes the mass defect.
  13. Nuclear Binding energy

    • Binding energy and fission
    • Nuclear Energy
    • The mass deficit comes about because a small amount of the mass of the nucleons is converted into energy needed to hold the nucleus together.
    • This energy needed to hold the nucleus together is called the nuclear binding energy.
    • It is calculated from Einstein's famous equation for the mass-energy relationship. The equation is in the previous slide.
    • There are 2 common systems of units for calculating binding energy. If you have calculated the mass deficit in kilograms then using c=3x10^8^2 will give the binding energy in joules.
    • Alternatively if you have calculated the mass deficit in atomic mass units, then you can convert this into binding energy in MeV using;
    • 1u = 931.5 MeV
  14. Binding energy per nucleon

    • How much energy would be needed to remove 1 nucleon from a nucleus.
    • To work this out we need to know both the binding energy of a nucleus, and the number of nucleons within it.
    • This gives us the binding energy per nucleon in MeV and from this, we can determine how strongly different nuclei are held together.
    • https://www.youtube.com/watch?v=9b8qZ6OHZ5s (Incorporar)
  15. Binding energy per nucleon graph

    • Binding energy per nucleon graph
    • Drawing a graph of binding energy per nucleon against mass number for the nuclei gives us a useful means of comparing how tightly different nuclides are bound together.
    • Looking at the graph on the right, a person will see that the isotope with the highest binding energy per nucleon is iron-56. Any nuclear reaction which increases the binding energy per nucleon will give out energy.
    • The graph shows that small nuclides can combine together to make large nuclei (up to Fe-56) with a greater binding energy per nucleon. This process is called nuclear fusion.
    • Similarly, larger nuclei can break up into smaller pieces which have greater binding energy per nucleon. Reactions like this are called nuclear fission. Both of these types of nuclear reaction will give out energy and could be used as power sources.
  16. Nuclear fusion

    • If we take some light nuclei and force them to join together, the mass of the new, heavier, nucleus will be less than the mass of the constituent parts, as some mass is converted into energy. This is called nuclear fusion.
    • However, not all of this energy, is used as binding energy for the new larger nucleus, so energy will be released from this reaction.
    • The binding energy per nucleon afterwards is higher than at the start. This is the process of nuclear fusion and is what provides the energy to make start shine.
    • https://www.youtube.com/watch?v=yTkojROg-t8 (Incorporar)
  17. Nuclear fusion part 2

    • Nuclear fusion gives out more energy per nucleon than nuclear fission and is a natural process in the sun.
    • Why does it give more energy than fission?
    • The increase in binding energy per nucleon are much larger for fusion than for fission reactions as seen by how the graph increases more steeply for light nuclei.
  18. Conditions needed for fusion

    • -A high temperature is required and this is due to the fact that a high temperature allows nuclei get close enough for fusion to occur as they have enough kinetic energy to over come the electrostatic force of repulsion.
    • -A high density is required as it gives a collision rate which is needed to sustain the fusion process.
  19. Nuclear fission

    • https://www.youtube.com/watch?v=mBdVK4cqiFs (Incorporar)
    • Nuclear fusion isn't yet an option for electricity generation as we haven't been able to create the high densities and temperature needed to sustain a fusion reaction.
    • However, another process which releases binding energy from nuclei is called nuclear fission. In this process a large nuclear breaks up into 2 smaller nuclei, with the release of some neutrons and energy.
  20. Why isn't nuclear fusion possible now?

    • Nuclear Fission and Fusion
    • Nuclear Physics: Radioactivity
    • Nuclear Physics
    • Nuclear Fission and Fusion
    • The main problem of getting two nuclei close enough for them long enough for them to fuse.
    • The enormous temperature and pressure in the Sun's core provide the right conditions.
    • On Earth's temperature of over 100 million Kelvin are needed. At this temperature all matter exists as an ionised gas or plasma.
    • Another problem is containment. What can you use to hold something this hot? JET (Joint European Torus) uses magnetic field in a doughnut-shaped chamber called a torus to keep the plasma away from the container walls.
    • Unfortunately generating high temperatures and strong magnetic fields uses up more energy than the fusion reaction produces.
  21. How does bombing the Uranium nucleas with neutron less stable?

    • https://www.youtube.com/watch?v=MGj_aJz7cTs (Incorporar)
    • When you bombard a uranium nucleus with neutrons can trigger fission reaction but how does bombing the uranium nucleus with neutron causes it to become unstable?
    • The strong forces that hold the nucleus together only acts over a very short distance.
    • When a uranium nucleus absorbs a neutron it knocks the nucleus out of shape. If the nucleus deforms enough, the electrostatic repulsion between the protons in each half becomes greater than the strong force. It then splits into 2.
    • The nucleus splits randomly.
  22. How does bombing the Uranium nucleas with neutron less stable? Part 2

    • When the uranium nucleus splits, a number of neutrons are also ejected. If each ejected neutron causes another uranium nucleus to undergo fission, we get a chain reaction and this will release a large amount of energy.
    • Uncontrolled chain reactions are used in nuclear bombs.
  23. Nuclear reactors

    • The most common nuclear fission reaction used in power stations is that of uranium-235 (U-235). if a nucleus of this uranium isotope is hit by a slow-moving neutron, often called a thermal neutron, it may absorb the neutron to form U-236, which is unstable and quickly breaks apart.
    • The products of this disintegration will be 2 medium-sized (& radioactive) nuclei with roughly half the nucleons each, plus a number of high speed neutrons.
    • There is a difference in the a,mount of binding energy in the U-236 and the daughter products. This is given off as the kinetic energy of the various particles and harnessed by the nuclear reactors to drive an electricity-generating system.
    • A moderator, such as water or graphite, is used to slow down the emitted neutrons so they arrived at the next uranium fuel rod at the slow speed needed to allow them to be absorbed by further U-235.
    • As each reaction requires only one neutron but produces two or three, this chain reaction could run out of control as is the case in an atomic bomb.
    • To control the reaction in a nuclear reactor, control rods typically made of cadmium or boron absorbs excess neutrons. These control rods are lowered into the reactor on an electromagnetic support.
    • If there is a failure in the control rods system, gravity will pull them completely down into the reactor core, where they will absorb all neutrons and shut down the reaction.
  24. Media of Nuclear reactors

Informações

Descrição
A-Level Physics (Unit 5) Slides sobre Nuclear Decay, criado por Haneen Al-Baghdadi em 07-04-2016.
Criado por
Haneen Al-Baghdadi · abr 2016
Atualizado
28 jun 2016
Visualizações
13
Avaliação

Mais sobre Radioactive Decay and Nuclear Equations

Fale Conosco

Sobre o que é sua mensagem?

O que a gente deve adicionar?