Quiz
Dependent (related) t-test
This quiz has question types that open in the usual player.
Questions in this quiz (21)
1We are looking for a test of [blank_start]difference[blank_end]
- Adifference
2What sort of data do we have
- Ainterval or ratio
- BNominal
- COrdinal
3What am I doing?
- ARepeated measures
- BIndependent groups
4The data used is parametric
- ATrue
- BFalse
5The dependent samples t-test . . .
- ACompares the medians of two independent groups
- BCompares the means of two independent groups
- CCompares the medians of two related groups
- DCompares the means of two related groups
- ENone of the above
6To carry out a dependent samples t-test . . .
- AThe data must be normally distributed
- BLevene's test must be significant
- CResults of the Kolmogorov-Smirnov test must not be significant
- DData must be measured on the interval or ratio level
- EData must be measured on the nominal or ordinal level
7When can you perform a dependent samples t-test?
- AWhen you want to compare the number of pull ups before to after 4 weeks of bootcamp training
- BWhen you want to compare the emotion recognition scores of males to females
- CWhen you want to compare the frequency of men to women studying Psychology
- DWhen you want to compare the pass rate of 3 year olds on an executive function task with the population mean
- EWhen you want to see if there is an association between age and height
8Dependent samples means . . .
- AThat the design of the study is between groups
- BThat each participant only contributes data to one cell of the analysis
- CThat the design of the study is within participants
- DThat each participant contributes to more than one cell of the analysis
- ENone of the above
- F3 and 4
9Below is an SPSS showing the results of a Kolmogorov Smirnov test on the memory scores of people before and after taking part in memory training with Derren Brown.
Referring to the SPSS output, which of the statements below are TRUE?
- AThe data for both samples need to be transformed before a dependent samples t-test can be used
- BThe results of the K-S test are significant for both groups
- CThe results of the K-S test are not significant for either group
- DIt is appropriate to conduct a dependent samples t-test on the data
- ENone of the above
10The SPSS output below shows the results of a dependent samples t-test comparing the memory scores of people before and after memory training with Derren Brown.
Referring to the SPSS output, what is the p value of the dependent samples t-test?
- Ap=.03
- Bp=-6.85
- Cp=.41
- Dp<.001
11Referring to the SPSS outputs above, which of the statements below are true?
- AThere are 28 participants in total
- BThere are 56 participants in total
- CThe mean memory score before training with Derren Brown was 12.54
- DMemory scores are higher after memory training with Derren Brown
- EDegrees of freedom are 25
12Referring to the SPSS output below, what is the correct way of reporting the dependent samples t-test?

- At(24)=+6.86, p<0.001
- Bt(27)=-2.42, p<0.001
- Ct(27)=-6.86, p<0.001
- Dt(24)=1.87, p<0.00
13Referring to the SPSS outputs above, what could you conclude from the results of the dependent samples t-test?
- AThere was no significant effect of memory training with Derren Brown on memory recall
- BParticipants recalled significantly more words before as compared to after memory training
- CParticipants recalled significantly more words after as compared to before memory training
- DThere was a significant effect of memory training on memory recall
14Related/dependent/[blank_start]paired[blank_end] samples/[blank_start]within[blank_end] groups/[blank_start]repeated[blank_end] measures
- Apaired
- Bwithin
- Crepeated
15Dependent samples (or paired) t-tests typically consists of a sample of matched pairs of similar units, or one group of units that has been tested twice (a 're[eated measures' t-test)
A typical example of the repeated measures t-test would be where subjects were tested prior to treatment, say for high blood pressure, and the same subjects are tested again after treatment with a blood pressure lowering medication- ATrue
- BFalse
16Decision rule: if the p-value of the obtained test statistic is [blank_start]less[blank_end] than .05, [blank_start]reject[blank_end] the null hypothesis, one tailed test
obtained test statistic: [blank_start]t[blank_end]
Decision: accept or reject null hypothesis- At
- Bless
- Creject
17To report an dependent t-test in APA format you need to know the degrees of freedom, the t-value and the p-value
the significance p-value
Divide by 2 to get one-tailed p-value
SPSS always gives you an output of a two-tailed test just divide the p-value in the SPSS output
However, if you have a value of .000 you just say less that 0.0001- ATrue
- BFalse
18Effect size is a simple way of quanitifying the difference between two groups
Effect size emphasises the size of the difference rather than confounding this with sample size. It is easy to calculate, readily understood and can be applied to any measured outcome in psychology
It is particularly valuable for quantifying the effectiveness of a particular intervention relative to some comparison. It allows us to be more [blank_start]simplistic[blank_end], 'Does it work or not? '
Effect size is a measure of the [blank_start]difference[blank_end] between the two [blank_start]samples[blank_end]- Adifference
- Bsamples
- Csimplistic
19There are two types of effect sizes; pearson r correlation and cohen's d
- ATrue
- BFalse
20pearson r correlation is one of the most widely used effect sizes. Pearson's r can vary from [blank_start]-1[blank_end] to [blank_start]1[blank_end] with -1 indicating a [blank_start]perfect negative relationship[blank_end] and [blank_start]0[blank_end] indicating no relationship between two variables
- A-1
- B1
- Cperfect negative relationship
- D0
21Cohen's d is the appropriate effect size measure to use in the context of a t-test on means, d is defined as the difference between two means divided by the [blank_start]pooled standard deviation[blank_end] for those means.
accepted view of how to interpret the resultant effect size:
0.2 is indicative of a small effect
[blank_start]0.5[blank_end] is a medium and
[blank_start]0.8[blank_end] is a large effect size
If you have a [blank_start]large effect size[blank_end] you wouldn't find it hard to replicate this
If you have a [blank_start]small effect size[blank_end] you may need a lot of people to actually find this- A0.5
- B0.8
- Cpooled standard deviation
- Dlarge effect size
- Esmall effect size
Information
- Description
- MY DEGREE Quiz on Dependent (related) t-test, created by Toyin Oshodi on 11/03/2017.
- Author
- Toyin Oshodi
- Language
- English
- Views
- 0
- Tags
- Rating
- No ratings yet Rate this quiz