Quiz
CCNA WIFU FOREIGN 5
This quiz has question types that open in the usual player.
Questions in this quiz (25)
1What are fouWhat are four features of WPA? (Choose four.)r features of WPA? (Choose four.)
- Aa larger initialization vector, increased to 48 bits
- Ba message integrity check protocol to prevent forgeries
- Cauthenticated key management using 802.1X
- Dsupport for a key caching mechanism
- Eunicast and broadcast key management
- Frequires AES-CCMP
2Which three options are limitations when configuring basic security on an autonomous AP when using the express security page setup? (Choose three.)
- AYou need multiple SSIDs.
- BDelete all the SSIDs
- CEdit the SSIDs.
- DUse multiple authentication servers.
- EUse the same SSID on both radios.
- FUse a single SSID on a single radio.
3Due to the terrain, a deployment requires a point-to-point wireless bridge to allow for network connectivity to a remote building. What 5GHz band would permitted to use the highest power in the U.S.?
- AU-NII-1
- BU-NII-2
- CU-NII-2 Extended
- DU-NII-3
4Which two menus do you click to determine the reachability status of a controller from Cisco WCS? (Choose two.)
- AMonitor
- BReports
- CConfigure
- DServices
- EAdministration
- FTools
5Which GUI item do you click to configure authentication and authorization in Cisco WCS?
- ASecurity
- BMonitor
- CConfigure
- DServices
- EAdministration
- FTools
6Refer to the exhibit. A help desk ticket has been entered for the wireless infrastructure. A wireless client is not able to connect at IEEE 802.11n rates. Which option allows for
connectivity?
- ASet WMM mode to Optional or Required.
- BSet Quality of Service (QoS) to Silver.
- CSet Quality of Service (QoS) to Platinum
- DSet 7920 AP CAC to Enabled.
7What two methods of authentication are available for Local EAP?
- ALDAP and RADIUS
- BLocal and RADIUS
- CLocal Only
- DLDAP and Local
8An engineer is deploying an autonomous AP, and the customer requests that all IEEE 802.11b data rates be disabled on the AP. Which interface must be amended to disable the 802.11b data rates on a Cisco Aironet 1252 Series Access Point?
- ADot11radio0
- BDot11radio1
- CGigabitEthernet0
- DBVI1
9The results of a Cisco WCS client troubleshooting tool are summarized into a simple visual representation of a four-part progression of the connection status for a wireless client. What are the four parts? (Choose four.)
- Aclient MAC address
- B802.11 authentication
- CIP address assignment
- D802.11 association
- Esuccessful association
- Fauthentication method
- GSSID
- Hclient radio type
10The IEEE 802.11n standard provides 40-MHz channels, improved MAC efficiency, and
MIMO. Which three elements define the 802.11n implementation of MIMO? (Choose three.)- Achannel bonding
- Bdynamic frequency selection
- Cmaximal ratio combining
- Dpacket aggregation
- Espatial multiplexing
- Ftransmit beam forming
11Which governing body analyzes the applications and environments in which wireless
networks are used?- AEIRP
- BETSI
- CFCC
- DIEEE
- EWiFi Alliance
12Which statement about the impact of configuring a single SSID to support TKIP and AES encryption simultaneously is true?
- AThe overhead associated with supporting both encryption methods significantly degrades client throughput.
- BSome wireless client drivers might not handle complex SSID settings and may be unable to associate to the WLAN.
- CThis configuration is unsupported and the Cisco Wireless Control System generates alarms continuously until the configuration is corrected.
- DThis configuration is common for migrating from WPA to WPA2. No problem is associated with using this configuration.
13When using DHCP option 43, the discovery option supports vendor specific identifiers in order to obtain what IP address?
- Acore router's gateway
- Bclosest distribution switch
- Clocal WLAN controller
- Dlocal Radius Server
14A WLAN deployment uses a combination of Cisco Aironet 1260 APs and multiple Cisco 5500 Wireless LAN Controllers to provide wireless LAN access to end-users. The network administrator has decided to use DHCP Option 43 to enable the APs to discover the wireless LAN controllers. When configuring the DHCP scope, which format should be used for the Cisco WLC addresses?
- Aa comma-separated ASCII string of Cisco WLC AP-manager addresses
- Ba comma-separated ASCII string of Cisco WLC management addresses
- Ca comma-separated ASCII string of Cisco WLC virtual IP addresses
- Da hexadecimal string of Cisco WLC AP-manager addresses
- Ea hexadecimal string of Cisco WLC management addresses
- Fa hexadecimal string of Cisco WLC virtual IP addresses
question_answerVIEW ANSWER
15What is the maximum number of access points supported on Cisco WCS with an enterprise license?
- A5,000
- B10,000
- C50,000
- D100,000
16When a wireless client is authenticated in a controller-based wireless network, which three pieces of source identification information can be used by the controller for an Access- Request message that is sent to an external RADIUS server? (Choose three.)
- Awireless client IP address
- Bcontroller IP address
- CAP IP address
- Dwireless client MAC address
- Econtroller MAC address
- FAP MAC address
17The existing Cisco Unified Wireless Controller is running version 7.0 code for both the controllers and the Cisco WCS. A controller has been configured with an appropriate rogue rule condition to report discovered APs to the Cisco WCS.
Which default alarm level is used to display all rogue APs in the Alarm Summary?- ACritical
- BFlash
- CUrgent
- DMajor
- EMinor
18What three components are required to configure Mobility Group Members between
Wireless LAN Controllers? (Choose three.)- AController Management IP Address
- BController Virtual IP Address
- CController Multicast IP Address
- DController MAC Address
- EController Mobility Group Name
- FController AP Management IP Address
- GController RF Group Name
19What are two wireless configuration utilities for Apple Mac computers? (Choose two.)
- AAirPort
- BAirPort Extreme
- CAirManager
- DAirManager Supreme
- EAirAssistant Ultimate
20A Cisco Aironet 1260 AP is unable to join a Cisco 2500 Series WLC that is connected
through a Layer 2 switch. Which three options help to verify the wireless network operation and locate a possible issue? (Choose three.)- AVerify status of GUI Wireless > Country
- BVerify status of GUI Wireless > Timers
- CVerify status of GUI WLANs > ID > Advanced
- DCLI debug of dot11
- ECLI debug of DHCP
- FVerify Cisco WLC license
- GVerify Cisco WLC model
21When using OFDM, how many subcarriers are devoted to carrying data?
- A4
- B12
- C44
- D48
- E52
22Which option describes why most wireless phones and tablets do not use 802.11a/n and 40 MHz channels?
- Aa lack of radio range when using these radios
- Ba lack of device battery capacity to operate concurrent a/b/g/n radios
- Ca lack of cooling in the device necessary to operate these radios
- DThese radios would require the devices to be larger.
question_answerVIEW ANSWER
23Which portion of a WLAN deployment can WLC message logs help to troubleshoot?
- ARF issues
- Bencryption issues between APs and clients
- Cconfiguration verification issues
- Dinfrastructure and client Issues
- EAP placement issues
24What are the interface statuses of a lightweight AP working in rogue-detection mode?
- Aradios turned off, Ethernet interface up
- Bradios and Ethernet interfaces up
- Cradios turned on, Ethernet interface shut down
- Dradios turned on, Ethernet interface status controlled by Cisco WLC
25Refer to the exhibit. WLC1 becomes unresponsive due to a power failure at a customer site. How does the access point that is shown in the WLC controller GUI behave now that WLC1 is disabled?

- Aassociates to controller 10.201.204.6
- Bassociates to controller 10.201.204.11
- Cassociates to controller 10.201.204.8
- Dassociates to controller 10.201.204.19 q
Information
- Description
- CCNA WIRELESS Quiz on CCNA WIFU FOREIGN 5, created by I L on 27/06/2017.
- Author
- I L
- Language
- English
- Views
- 4
- Tags
- Rating
- No ratings yet Rate this quiz
More on WLAN Design, Configuration and Deployment