Gestalte GoConqr mit. Was sollen wir als Nächstes hinzufügen?

Quiz

MEF-CLOUDCAMPUS AULA 08-09

fdsqwertyfds qwerty 27 Fragen Aktualisiert am 2 Nov 2016

Quiz starten

Fragen in diesem Quiz (27)

  1. 1Which one of the following statements describes how frame loss ratio (FLR) is measured for an EPL service?
    1. Aa. For each EVC CoS, count all green frames sent and received over an agreed time interval.
    2. Bb. For each EVC CoS, count all green and yellow frames sent and received over an agreed time interval.
    3. Cc. For an EVC, count all green and yellow frames sent and received over an agreed time interval.
    4. Dd. For an EVC, count all frames sent and received (regardless of CoS) over an agreed time interval.
  2. 2NE A and NE B are connected by an Ethernet link. Brian, an operator, has access only to NE B (NE B is in Brian's domain of operations, but NE A is not). Which two options below can be available (with correct provisioning) to Brian? (Choose two)
    1. Aa. Use RDI to initiate LOAM link discovery.
    2. Bb. Use SOAM loopback to verify link connectivity.
    3. Cc. Use LOAM loopback to redirect all traffic at NE B back toward NE A.
    4. Dd. Use LOAM loopback to redirect all traffic at NE A back toward NE B.
    5. Ee. Use SOAM loopback to redirect all traffic at NE A back toward NE B.
  3. 3Which of the following is not an SOAM frame?
    1. Aa. Alarm Indication Signal (AIS)
    2. Bb. Remote defect indication (RDI)
    3. Cc. Loss Measurement Message (LMM)
    4. Dd. Connectivity Check Message (CCM)
  4. 4Which two of the following statements are correct ? (Choose two)
    1. Aa. An ME can include any number of MIPs.
    2. Bb. SOAM domains can overlap.
    3. Cc. An ME can include more than two MEPs.
    4. Dd. LOAM support is required for Type 2.1 UNIs and at ENNIs.
    5. Ee. SOAM CCMs can support 50 ms protection switching.
  5. 5If a MEP sends a Loss Measurement Message (LMM), where does it go?
    1. Aa. To all MEPs in the MEG
    2. Bb. To peer MIPs in the same ME
    3. Cc. To all MIPs in every ME
    4. Dd. To the peer MEP in the same ME
    5. Ee. To all MEPs in every ME
  6. 6Per MEF 30.1, to whom does the EVC MEG belong?
    1. Aa. Subscriber and Operator
    2. Bb. Operator
    3. Cc. Operator and Service Provider
    4. Dd. Subscriber
    5. Ee. Service Provider
  7. 7MEP clock synchronization is required to measure which two of the following? (Choose two)
    1. Aa. One‐way delay with the Dual‐Ended Delay function
    2. Bb. One‐way delay with the Single‐Ended Delay function
    3. Cc. Two‐way delay with the Single‐Ended Delay function
    4. Dd. Two‐way delay with the Dual‐Ended Delay function
  8. 8To isolate a fault within a point‐to‐point OVC, an operator can:
    1. Aa. Send a frame loss measurement message (LMM) to the appropriate peer MEP.
    2. Bb. Initiate SOAM Loopback over the appropriate ME.
    3. Cc. Process the most recent remote defect indicator (RDI) per IEEE 802.1Q.
    4. Dd. Inspect all continuity check messages (CCMs) for the appropriate ME.
    5. Ee. Initiate SOAM Link Trace over the appropriate ME.
  9. 9Which Maintenance Entity (ME) should the service provider use to monitor the performance of an Ethernet service that spans two Operator MENs?
    1. Aa. Operator ME
    2. Bb. UNI ME
    3. Cc. EVC ME
    4. Dd. ENNI ME
    5. Ee. Subscriber ME
  10. 10Which two SOAM frames are used for performance monitoring? (Choose two)
    1. Aa. LBM (Loopback Message)
    2. Bb. LTM (Link Trace Message)
    3. Cc. CCM (Continuity Check Message)
    4. Dd. DMM (Delay Measurement Message)
    5. Ee. LMM (Loss Measurement Message)

Informationen

Beschreibung
Todos as disciplinas Geral (MEF) Quiz am MEF-CLOUDCAMPUS AULA 08-09, erstellt von fdsqwertyfds qwerty am 18/10/2016.
Sprache
Português
Aufrufe
2
Verlauf
Erstellt am 18 Okt 2016 · aktualisiert am 2 Nov 2016
Schlagwörter
geralmeftodos as disciplinas
Bewertung
Noch keine Bewertungen
Bewerte dieses Quiz
Bewerte dieses Quiz

Mehr zu Carrier Ethernet Services

Feedback

Worum geht es?

Was sollen wir als Nächstes hinzufügen?