Quiz
Chapter 7
Erstelle ein kostenloses Konto, um dieses Quiz zu beenden
Speichere deinen Fortschritt und sieh dir dein Endergebnis an.
oder mit deiner E-Mail registrieren
Schon ein Konto? Anmelden
Fragen in diesem Quiz (19)
1Which two statements are true regarding classless routing protocols? (Choose two.)
- Aallows for use of both 192.168.1.0/30 and 192.168.1.16/28 subnets in the same topology
- Bis supported by RIP version 1
- Csends subnet mask information in routing updates
- Dsends complete routing table update to all neighbors
- Ereduces the amount of address space available in an organization
2Refer to the exhibit. OSPF is used in the network. Which path will be chosen by OSPF to send data packets from Net A to Net B?
- AR1, R4, R6, R7
- BR1, R3, R6, R7
- CR1, R3, R5, R6, R7
- DR1, R2, R5, R7
- ER1, R3, R5, R7
3Refer to the exhibit. Based on the partial output from the show ip route command, what two facts can be determined about the RIP routing protocol? (Choose two.)
- ARIP version 1 is running on this router and its RIP neighbor.
- BRIP version 2 is running on this router and its RIP neighbor.
- CThe command no auto-summary has been used on the RIP neighbor router.
- DRIP will advertise two networks to its neighbor.
- EThe metric to the network 172.16.0.0 is 120.
4Which two statements describe the OSPF routing protocol? (Choose two.)
- Aautomatically summarizes networks at the classful boundaries
- Bused primarily as an EGP
- Cuses Dijkstra’s algorithm to build the SPF tree
- Dhas an administrative distance of 100
- Ecalculates its metric using bandwidth
5What is the purpose of the passive-interface command?
- Aallows a router to send routing updates on an interface but not receive updates via that innterface
- Ballows interfaces to share IP addresses
- Callows a router to receive routing updates on an interface but not send updates via that interface
- Dallows an interface to remain up without receiving keepalives
- Eallows a routing protocol to forward updates out an interface that is missing its IP address
6In the context of routing protocols, what is a definition for time to convergence?
- Aa measure of protocol configuration complexity
- Bthe capability to transport data, video, and voice over the same media
- Cthe amount of time for the routing tables to achieve a consistent state after a topology change
- Dthe amount of time a network administrator needs to configure a routing protocol in a small- to medium-sized network
7Which two events will trigger the sending of a link-state packet by a link-state routing protocol? (Choose two.)
- Athe requirement to periodically flood link-state packets to all neighbors
- Ba change in the topology
- Cthe initial startup of the routing protocol process
- Dthe router update timer expiring
- Ea link to a neighbor router has become congested
8The command _________ is used in RIP router configuration mode to enable the sending of subnet masks with the routing updates.
- Aversion 2
- Bversion 3
9What two actions result from entering the network 192.168.1.0 command in RIP configuration mode on a router? (Choose two.)
- AThe RIP process is stopped and all existing RIP configurations are erased.
- BThe neighboring routers are sent a request for routing updates.
- CRouting updates are sent through all the interfaces belonging to 192.168.1.0
- DThe network address 192.168.1.0 is advertised to the neighbor routers
- EThe routing table is created in the RAM of the router.
10What two tasks do dynamic routing protocols perform? (Choose two.)
- Anetwork discovery
- Bupdate and maintain routing tables
- Cdiscover hosts
- Dpropagate host default gateways
- Eassign IP addressing
11Refer to the exhibit. Which interface will be the exit interface to forward a data packet with the destination IP address 172.16.0.66?
- ASerial0/0/0
- BSerial0/0/1
- CGigabitEthernet0/0
- DGigabitEthernet0/1
12Which route is the best match for a packet entering a router with a destination address of 10.16.0.2?
- AS 10.0.0.0/16 is directly connected, Ethernet 0/0
- BS 10.16.0.0/16 is directly connected, Ethernet 0/1
- CS 10.16.0.0/24 [1/0] via 192.168.0.9
- DS 10.0.0.0/8 [1/0] via 192.168.0.2
13When configuring RIPng, the default-information originate command instructs the router to propagate a static default route
- Adefault-information originate
- Bnot the right answer
14What is different between IPv6 routing table entries compared to IPv4 routing table entries?
- AIPv6 does not use static routes to populate the routing table as used in IPv4.
- BThe selection of IPv6 routes is based on the shortest matching prefix, unlike IPv4 route selection which is based on the longest matching prefix.
- CIPv6 routing tables include local route entries which IPv4 routing tables do not.
- DBy design IPv6 is classless so all routes are effectively level 1 ultimate routes.
15Which two requirements are necessary before a router configured with a link-state routing protocol can build and send its link-state packets? (Choose two.)
- AThe router has constructed an SPF tree.
- BThe router has built its link-state database.
- CThe router has established its adjacencies.
- DThe router has determined the costs associated with its active links.
- EThe routing table has been refreshed.
16Which dynamic routing protocol was developed as an exterior gateway protocol to interconnect different Internet providers?
- AOSPF
- BEIGRP
- CRIP
- DBGP
17Which two requirements are used to determine if a route can be considered as an ultimate route in a router’s routing table? (Choose two.)
- Acontain subnets
- Bcontain a next-hop IP address
- Ccontain an exit interface
- Dbe a default route
- Ebe a classful network entry
18A destination route in the routing table is indicated with a code D. Which kind of route entry is this?
- Aa route dynamically learned through the EIGRP routing protocol
- Ba network directly connected to a router interface
- Ca route used as the default gateway
- Da static route
19Which route will a router use to forward an IPv4 packet after examining its routing table for the best match with the destination address?
- Aa level 1 ultimate route
- Ba level 2 supernet route
- Ca level 1 parent route
- Da level 1 child route
Informationen
- Beschreibung
- Quiz am Chapter 7, erstellt von Tim Tam am 02/09/2014.
- Autor
- Tim Tam
- Sprache
- English
- Aufrufe
- 29
- Bewertung
- Noch keine Bewertungen Bewerte dieses Quiz