Flashcards
DT equipment
Cards in this deck (43)
- 1—G Clamp
Clamps your work while working. - 2—One handed G Clamp
Clamps hold your work whilst working
- 3—Spring Clamp
Holds work usually when glueing.
- 4—Woodwork Vice
Mounted level with the top of the work bench. For holding wood.
- 5—Metal Work Vice
Mounted on the top of the work bench. Holding plastic and metal
- 6—Drill Vice
Holding work whilst drilling on the pillar drill
- 7—Pliers
Gripping things some pliers have a cutting edge.
- 8—Long Nose Pliers
Gripping things some pliers have a cutting edge.
- 9—Tenon Saw
Straight cuts in wood.
- 10—Hack and Junior Hack Saw
Saw for metal and plastic.
- 11—Coping Saw
Cuts curves in wood
- 12—Stanley Knife
For cutting paper, card, thin wood and plastic.
- 13—Chisel
For chiselLing wood.
- 14—Electric Fretsaw
Cuts curves in wood and plastic
- 15—Side Cutters
For cutting wire and thin material.
- 16—Smoothing plane
Smoothing the surface of wood by cutting off a thin layer.
- 17—Block Plane
- 18—File
Remove rough edges
- 19—Disc Sander
Sanding curves and straight edges
- 20—Orbital Sander
Sanding
- 21—Sand/glass paper
Smoothing wood
- 22—Silicon carbide paper
Smoothing metal and plastic
- 23—Steel Rule
Measuring
- 24—Safety Ruler
Measuring and for cutting against
- 25—Steel Tape
Measuring longer lengths
- 26—Try Square
Marking a right angle on wood or plastic
- 27—Vernier Calipers
Measuring the outside and inside diameter of an object
- 28—Chinagraph Pencil
Marking out on metal and plastic
- 29—Pencil
Marking out on wood
- 30—Cordless Drill
For drilling and it can be used as a screwdriver if you add a screwdriver bit.
- 31—Pillar Drill
Drilling
- 32—Drill Bits
Cut holes
- 33—Countersinking bit
Drills/cuts a conical shaped hole
- 34—Screwdriver and screws
Joining materials together
- 35—Hammer and Nails
Joining materials together
- 36—Glue Gun
Gluing
- 37—PVA Glue
Wood glue
- 38—Epoxy Resin
Gluing any material, but too expensive to do large areas.
- 39—Polystyrene Cement
Gluing polystyrene
- 40—Soldering Iron and Soldering Iron Stand
Soldering
- 41—Band Saw
Cutting wood and plastic
- 42—Strip heater
Melts plastic along a line to fold it
- 43—Vacuum Former
Vacuum forming
Information
- Description
- Flashcards on DT equipment, created by maddiestares on 21/05/2015.
- Created by
- maddiestares
- Views
- 0
- Rating