Lakshan flowcart 1

START

Mark out the measurement on the acrylic pieces using the steel ruler, pencil and tri-square.

Cut out the design shape on the acrylic pieces using the scroll machine.

Shape the design pieces of acrylic using hand file and disc-sander machine

Is the design shape successful?

Is there any hole needed to drill in a drill machine?

Remove the mark on the edges of the acrylic using hand file

Are all the hard marks removed

Use the dry- and -wet paper to remove all the fine marks on the edges of the acrylic

Drill the hole on the materials on the drilling machine and using the correct drill bit size

Is the hole drilled a successful

Are all the scratch marks removed

Polish the edges of the acrylic pieces to shine on a buffing machine.

Are all the edges of the acrylic shiny?

Is there any section needed to be bent by using a strip heater??

NO

NO

NO

NO

YES

YES

YES

NO

YES

NO

Soften the section on the acrylic using the strip heater

Was the bending successful?

NO

The making on this part of the artifact is done

YES

END

YES

NO

YES