Untitled

start

list out all the necessary measurement of my design using steel ruler, pencil and tri- square on the raw acrylic material

Using a scroll machine to cut out the design on the materials

the use of chloroform to attach all the pieces together

The use of lathe machine to clamp all the acrylic

are the acrylic aligned safely and correctly?

proceed to cut the acrylic on the lathe

is the required diameter obtained?

is there a need to drill a center hole in the acrylic ?

using the correct drill bit size to drill the hole on the materials on the lathe machine

is the hole diameter correct?

To remove all the fine marks on the edges of the acrylic, i used the dry and wet paper

are all the fine marks removed?

using the lathe machine to polish the edge to make it shine

are all the edge shined?

the completion of this part of the product is done

end