Untitled

Start

i marked out the measurement that i need for my design by using a steel ruler,pencil and a tri-square on the acrylic material

i first start by cutting out the design in my product by using the scroll machine

After that,i start to shape the design of my product on the acrylic that i cut by using the hand file and the disc sander machine

Was the design shape obtained?

was there any hole to drill in my product?

I remove the markings on the edges of the acrylic by using hand file

Is the Marks all removed

To remove the marks on the edges of the acrylic,i use dry-and-wet sand paper

Are all the Marks removed?

Drill a hole on the acrylic by using the drilling machine and using the right drill bit size

Are all the holes drilled and completed?

Shine and polish by using the buffing machine

Is the edge all shined and polished?

Any need for any bending using a strip heater in my product?

Soften the area on the acrylic by using the strip heater

Is the bending correct as wanted?

The Part of making this section of my artefact is completed

End

NO

YES

NO

NO

YES

YES

NO

YES

YES

YES

NO

YES

NO

NO

YES

NO

YES