Operational Decision Making - Midterm Study Guide

Which of the following is not one of the 3 Rs?

Which of these pairs of functions would tend to be affected most dramatically by a product or service redesign?

Which of the following is not an advantage of standardization?

Excitement characteristics are categories in the _________ model.

In the area of product and service design, the acronym CAD refers to:

Which one of the following is not necessarily a factor of successful product and service design?

The assessment of the environmental impact of a product or service throughout its useful life is:

The process of dismantling and inspecting a competitor's new or revised product for the purpose of design ideas is called:

The term "standardization" is closely associated with:

The structural approach for integrating customer requirements into every aspect of product development is known as:

Job shops tend to be __________ while continuous processes tend to be __________.

The estimation of costs is generally most difficult when the ___________ process has been chosen.

Which of the following is not a process commonly considered in making products?

The type of processing system which is used for highly standardized products is:

Computer-aided refers to the use of computers in:

In which type of operation are you likely to see, at most, only minor variations in the product or service produced using the same process and the same equipment?

The process of assigning tasks to workstations in such a way that the workstations have approximately time requirements is called:

Which type of processing system tends to produce the most product variety?

In which type of processing system would gasoline be produced from crude oil?

In which type of processing system would Coca Cola be produced?