Mind map
Chapter 8: DHCP
Map content
Chapter 8: DHCP
DHCP is available for both IPv4 (DHCPv4) and IPv6 (DHCPv6).
- The use of a centralized DHCP server allows organizations to manage all IP address assignments from a single server.
- DHCPv4 assigns IPv4 addresses and other network configuration information dynamically.
- A dedicated DHCPv4 server is scalable and relatively easy to administer.
- The use of a centralized DHCP server allows organizations to manage all IP address assignments from a single server.
Operation of DHCPv4
- Origin of the lease
- DHCP detection (DHCPDISCOVER)
- DHCP offer (DHCPOFFER)
- DHCP request (DHCPREQUEST)
- DHCP acknowledgment (DHCPACK)
- Renovation of the lease
- DHCP request (DHCPREQUEST)
- DHCP acknowledgment (DHCPACK)
DHCPv4 message format
- Operation code (OP)
- Type of hardware
- Hardware address length
- Jumps
- Transaction identifier
- Seconds
- Indicators
- Client's IP address
- Your IP address
- IP address of the server
- IP address of the gateway
- Customer hardware address
- Server name
- Boot file name
- DHCP options
Discover (Discovery) and Offer (Offer) messages from DHCPv4
- If a client is configured to receive its IPv4 configuration dynamically and wishes to join the network, it requests address values from the DHCPv4 server.
- The client transmits a DHCPDISCOVER message on its local network when it starts or detects an active network connection.
- The client and the server send acknowledgment messages, and the process ends.
Configuring a basic DHCPv4 server
- Exclude IPv4 addresses
- Configure a DHCPv4 pool
- Configure specific tasks
- Disabling DHCPv4
Verification of DHCPv4
- show ip dhcp binding
- show ip dhcp server statistics
Relay of DHCPv4
- In a complex hierarchical network, business servers are usually located in a server farm
Automatic state-independent address configuration (SLAAC)
- Automatic configuration of stateless address
- Dynamic host configuration protocol for IPv6 (DHCPv6 with status)
Operation of SLAAC
- A router must have IPv6 routing enabled before it can send RA messages
- Router(config)# ipv6 unicast-routing
- A router must have IPv6 routing enabled before it can send RA messages
SLAAC and DHCPv6
- The decision of whether a client is configured to obtain its IPv6 address information automatically by SLAAC, by DHCPv6 or by a combination of both depends on the configuration within the RA message.
Configuring a router as a stateless DHCPv6 server
- Enable IPv6 routing
- Configure a DHCPv6 pool
- Configure pool parameters
- Configure the DHCPv6 interface
Information
- Description
- corhuila Ingeniería Mind Map on Chapter 8: DHCP, created by HERNAN DAVID VILLABON SANCHEZ on 31/10/2018.
- Created by
- HERNAN DAVID VILLABON SANCHEZ
- Views
- 4
- Rating
More on DHCP and address allocation