Flowchart

Lakshan flowcart 2

LAKSHAN S/O SILVAGANAPATHY English

Flowchart content

START
Mark out the measurement according to my design using steel ruler,pencil and tri-square on the raw peice of acrylic
Cut out the piece of acrylic according to my design using the scroll machine
Chloroform the pieces of acrylic together
Clamp the pieces of chloroformed acrylic on the lathe machine
Are the alignment of the acrylic correct?
Start cutting the acrylic on the lathe
Managed to get the correct diameter?
Is there a need to drill a center hole on the piece of acrylic?
Drill the hole on the materials on the lathe machine and using the correct drill bit size
Is the diameter of the hole correct??
Use the dry and wet sandpaper to remove the fine marks at the edges of the acrylic pieces.
Managed to remove all the fine marks on the acrylics?
Polish the edge to shine on the lathe machine
Are all the edges of the acrylic shiny?
Managed to finish this of the artefact
END
YES
NO
NO
YES
NO
NO
NO
YES
NO
YES

Description: Flowchart on Lakshan flowcart 2, created by LAKSHAN S/O SILVAGANAPATHY on 10/06/2019.
Created by: LAKSHAN S/O SILVAGANAPATHY
Views: 1
Rating