Setup Processes

Setup Processes

1. Vacuum former

2. Lathe

   • step 1) Mark the centres on each end of the wood and cut a groove for the driving centre step 2) plane off the corners using a smooth plane to reduce the gouge jamming Step 3) mount the lathe step 4) "rough turn the cylinder" i.e. remove unwanted material step 5) turn the material to the desired profile step 6) use sandpaper to achieve the smoothest surface possible step 7) apply a protective finish on the lathe using a brush step 8)part off the piece from the unwanted material

3. Pillar drill

   • Pillar drill is used to drill holes with drill bits

4. Laminating

   • when you put thin sheets of wood on your product to make it look aesthetically pleasing

Images and files in the map