Help shape GoConqr. What should we add next?

Mind map

2.1.e Implement and troubleshoot EtherChannel

flplira English

Map content

2.1.e Implement and troubleshoot EtherChannel

  1. 2.1.e [iv] Etherchannel misconfiguration guard

    • EtherChannel guard to detect an EtherChannel misconfiguration if your switch is running PVST +, rapid PVST +, or MSTP.
    • EtherChannel guard places the switch interfaces in the error-disabled state
  2. 2.1.e [ii] Layer 2, layer 3

    • channel-group channel-group-number mode {auto [non-silent] | desirable [non-silent] | on} | {active | passive}
    • interface port-channel port-channel-number
  3. 2.1.e [i] LACP, PAgP, manual (ON)

    • LACP (802.3ad)
      • Passive
      • Active
    • PAgP
      • Desirable
      • Auto
  4. 2.1.e [iii] Load-balancing

    • port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac}
    • src-dst-mixed-ip-port vlan included mpls label-ip
  5. Cisco switches support max 64 EtherChannels

  6. Same speed and duplex settings. Same operating mode (trunk, access, dynamic). If not trunking, same access VLAN. If trunking, same trunk type, allowed VLANs, and native VLAN. On a single switch, each port in a Port-channel must have the same STP cost per VLAN on all links in the Port-channel. No ports can have SPAN configured.

Information

Description
Mind Map on 2.1.e Implement and troubleshoot EtherChannel, created by flplira on 28/08/2015.
Created by
flplira
Views
2
Rating

More on EtherChannel and Link Aggregation

Feedback

What is it about?

What should we add next?